Moving Floor Semi-Trailer Tonar SDP3-89
The moving floor consists of a series of longitudinal aluminum beams, which are hydraulically driven. The drive is three-sectioned. Each section of beams is operated by its own hydraulic cylinder. The beams perform reciprocating movements in the longitudinal direction. During unloading and loading, all beam sections move simultaneously (beam stroke is 200 mm). On the return stroke, the sections move sequentially. The cycles then repeat and the cargo is moved. Full unloading time is 15 minutes.
There is no risk of the semi-trailer tipping over during unloading, compared to semi-trailers with a tipping body lift. Loading and unloading are performed horizontally, so relative unevenness and unstable ground at unloading sites are not dangerous. Unloading can be carried out in rooms with a ceiling height only slightly higher than the semi-trailer itself (low warehouses, factory workshops, woodworking plants). Full control of the hydraulic system is provided by a manual remote control panel. The moving floor design does not require any scheduled technical maintenance during operation. It is possible to load and unload without using a forklift inside the body.
| All semi-trailers with moving floors |
Moving Floor Semi-Trailer Tonar SDP3-89
- Characteristics
- Equipment
- Documentation
Dimensions:
Width (internal dimensions), mm2480
Fifth wheel height, mm1150
Length (internal dimensions), mm14100
Height (internal dimensions), mm2495
Weight:
Carried cargo weight (technically permissible), kg29800
Load on fifth wheel, kg11300
Axle load, kg27000
Curb weight of the semi-trailer, max, kg8500
Tonar Axles:
Wheel axlesTonar
Tirestubeless 385/65R 22.5
Lifting axlefront
Suspensiondependent, on longitudinal elastic arms with pneumatic elastic elements and telescopic hydraulic shock absorbers
Advantages:
Aluminum body
New tarpaulin/tension design
Aluminum swing rear doors
New platform on front board
Lightweight frame design
Other Specifications:
Rear wallaluminum swing gates
Side wallsmade of aluminum profile
Floorsliding floor system
Body volume, cu.m89 / 82
Support devicefor 24 tons
Moving Floor Semi-Trailer Tonar SDP3-89
The moving floor consists of a series of longitudinal aluminum beams, which are hydraulically driven. The drive is three-sectioned. Each section of beams is operated by its own hydraulic cylinder. The beams perform reciprocating movements in the longitudinal direction. During unloading and loading, all beam sections move simultaneously (beam stroke is 200 mm). On the return stroke, the sections move sequentially. The cycles then repeat and the cargo is moved. Full unloading time is 15 minutes.
There is no risk of the semi-trailer tipping over during unloading, compared to semi-trailers with a tipping body lift. Loading and unloading are performed horizontally, so relative unevenness and unstable ground at unloading sites are not dangerous. Unloading can be carried out in rooms with a ceiling height only slightly higher than the semi-trailer itself (low warehouses, factory workshops, woodworking plants). Full control of the hydraulic system is provided by a manual remote control panel. The moving floor design does not require any scheduled technical maintenance during operation. It is possible to load and unload without using a forklift inside the body.
| All semi-trailers with moving floors |
Sales Department
Other products Tonar
Мы всегда шли за потребителем. Делали именно то, что требовалось людям в данный момент. И это помогало нам устоять и идти вперед.
